Updating bios asus rom

29-Jan-2017 06:21

Your computer's BIOS - Basic Input/Output System - is a chip on the motherboard which contains enough information to allow it to start up before the main operating system begins to load.

(Select Tools YES)Wait for your system to check current BIOS information. Select the drive letter with the BIOS update file, then select the file. After the file check is finished, click "Yes" to update your BIOS. When the update is finished, remove the floppy or USB drive and reboot.Enter the BIOS Menu and load "Setup Default."Reboot. If it isn't installed already, install the ASUS Update utility.A computer's Basic Input-Output System (BIOS) is embedded software on a motherboard.If the BIOS file is too large to fit with boot files, consider using the EZ Flash method described below.)Insert the motherboard support CD into optical drive. The final message will be "Verifying flash." DO NOT switch off or reboot at any point in this process or you will ruin your motherboard.After the update is complete, the utility will return to the DOS prompt. Enter the BIOS Menu and load "Setup Default."Save and reboot. Copy your new BIOS files to a floppy disk or USB drive. When the system is at POST, press "Alt" "F2" to enter EZ-Flash.

(Select Tools YES)Wait for your system to check current BIOS information. Select the drive letter with the BIOS update file, then select the file. After the file check is finished, click "Yes" to update your BIOS. When the update is finished, remove the floppy or USB drive and reboot.Enter the BIOS Menu and load "Setup Default."Reboot. If it isn't installed already, install the ASUS Update utility.A computer's Basic Input-Output System (BIOS) is embedded software on a motherboard.If the BIOS file is too large to fit with boot files, consider using the EZ Flash method described below.)Insert the motherboard support CD into optical drive. The final message will be "Verifying flash." DO NOT switch off or reboot at any point in this process or you will ruin your motherboard.After the update is complete, the utility will return to the DOS prompt. Enter the BIOS Menu and load "Setup Default."Save and reboot. Copy your new BIOS files to a floppy disk or USB drive. When the system is at POST, press "Alt" "F2" to enter EZ-Flash.Do not disconnect power at any time during this process. When updating via internet, most boards will store the update locally, wipe the old firmware, and then apply the update.